infolettre-EN

 

calendrier d'événements
November 2017
S M T W T F S
29 30 31 1 2 3 4
5 6 7 8 9 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28 29 30 1 2

Laboratories and Equipment

CRIQ carries out its R&D projects, tests, demonstrations, and specialized analyses using state-of-the-art facilities and equipment.

Here is a brief overview of a few of CRIQ’s facilities:

  • 3D Printing laboratory
  • Air and odour analysis laboratory
  • Extraction pilot plant
  • Multi-channel frequency analyzer for acoustic and vibration measurements
  • Three equipment development workshops (30,000 square feet)
  • Base for mechanical testing using actuators with varying capacities
  • Métalaser welding centre (source: high-powered YAG laser)
  • 3-metre anechoic chambers (emission and immunity) for electromagnetic compatibility tests (EMC)
  • Data acquisition systems
  • Altitude chamber
  • Moisture chambers
  • Chamber for HALT and HASS reliability testing
  • Aeromedical certification testing equipment
  • IP and NEMA seal testing chamber (water and dust)
  • Additional test sites (DES, surge, transients, etc.) for European certification
  • Temperature chambers
  • Laboratory columns: small volume units, highly flexible
  • FTIR (Fourier Transform Infra-Red spectroscopy)
  • GG-MS (gas chronomatography – mass spectrophotometry)
  • CP (induced coupled plasma)
  • Full analysis laboratory (FTIR, FTIR-PAS, AA)
  • Test laboratories for experimental models
  • Biofiltration pilot laboratory
  • Artificial vision laboratory
  • Multi-material processing platform (total capacity 8,000 m3)
  • Outdoor composting platform (3,500 m2 of which 350 m2 covered)
  • Weather station
  • Air aspiration and injection system
  • Water injection and collection system
  • Gas sensor and filtration system
  • Vibration, shock, fall and rebound tables (ISTA testing)
  • Pre-industrial laboratory unit unit for biofiltration intended for final adjustments prior to scaling
  • Pilot laboratory or land units